can't make bracket attach right side up

throbert · Post by **throbert** » Sun Feb 09, 2014 11:51 pm

I want to attach a U bracket with the legs down and there is no way to flip it around in the editor. Doesn't matter How I view it, it's always upside down

throbert · Post by **throbert** » Mon Feb 10, 2014 6:31 am

oh great her's another problem,
I open my U bracket then go to library click create sub Assembly, it tells me to pick the face to mate, the next screen comes up and I name it. I then load my case and click edit followed by click the face to attach to. in the edit screen I pick the part to attach and place it. back in the case 3D instead of mating to the face of the sub part I picked earlier it attaches to the web part of the U bracket and it's sticking through the lid.
If I had CAD I'd have been done a long time ago and I barely know CAD.

dronne · Post by **dronne** » Mon Feb 10, 2014 8:43 am

I am sorry you are finding it difficult to use, the bracket sub assembly is a brand new feature and we forgot to add the ability to flip it around. No excuses, all I can say is I'm sorry, I will fix that immediately. Should be putting out a maintenance release this week and there is no reason we can't get that done for this release.

Sincerest apologies,

throbert · Post by **throbert** » Mon Feb 10, 2014 11:24 am

Was wondering if you will be able to do this on the back of the 5U case i'm trying to design? I know there's know way I can get it on your design app.

throbert · Post by **throbert** » Mon Feb 10, 2014 11:26 am

dronne · Post by **dronne** » Thu Feb 13, 2014 1:24 pm

The brackets now install properly with this build:

http://forum.protocase.com/viewtopic.ph ... cab65#p676

I will have our tech person check the forum out and get you an answer on the rear panel.

ProtocaseDesigner.com