Annoying issue with grouping in PC 4 on Linux

[tweekzilla]

I'm trying to place four standoffs at the position of the holes on the circuit board. I place four on the base of the part and then align them to their tops. The really really annoying issue is that if I try and set the distance between them and you try and delete the value in the X-difference column it is very very easy to delete the standoffs. To make the matter even worse undo does not actually bring them back - It makes using the designer almost impossible to use as one small mistake is undoable and forces you to start from scratch on the placement.

[dronne]

Hello,

If you check out the current beta version of designer at http://www.protocasedesigner.com/RELEAS ... -Nov25.exe you will find that the undo works in this instance. I am sorry you had trouble with the previous version.

Sincerely,