Greetings,
I am trying to modify part of an ATX Assembly template but am prompted with the following error: "This is a templated face, and cannot be edited." How can I modify the area above the rear I/O panel of the chassis? It's the part in green in the attached image.
I would like to add some 80mm fan cutouts and or vent cutouts.
TIA,
Zain
This is a templated face, and cannot be edited.
Moderators: Colin, dronne, mpyne, akirk, mrodden
Re: This is a templated face, and cannot be edited.
Below is the screenshot of the error.
The PDA file is located on my GDrive as it is too large to post here.
https://drive.google.com/file/d/1dAQ2jh ... sp=sharing
The PDA file is located on my GDrive as it is too large to post here.
https://drive.google.com/file/d/1dAQ2jh ... sp=sharing
Re: This is a templated face, and cannot be edited.
Hello Zain,
Some faces are not editable due to manufacturing reasons. However in this case I think it's fine. I have set the particular face you are wanting to edit as editable. Attached is the file.
Matt Best Regards,
Some faces are not editable due to manufacturing reasons. However in this case I think it's fine. I have set the particular face you are wanting to edit as editable. Attached is the file.
Matt Best Regards,
Re: This is a templated face, and cannot be edited.
Awesome, thanks!