Generalized Sheet Metal Bender

Bulletins and Comments about future work on Protocase Designer

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
dronne
Posts: 353
Joined: Wed Nov 18, 2009 10:54 am

Generalized Sheet Metal Bender

Post by dronne »

Ultimately, we would like to be able to draw a flat pattern, put bend lines in it, and see a 3D model develop. This is not too far off - the difficult part is putting in limitations so that you do not draw anything that you can not build.
--Douglas Ronne
Lead Developer

Post Reply