How hard would this be?
Moderators: Colin, dronne, mpyne, akirk, mrodden
How hard would this be?
https://www.velkase.com/products/velka-7 oh almost how I want it, accept the GPU is vertical. How easy would it be to have the gpu face the same way as the MB?
Re: How hard would this be?
Hello Edward,
It should be possible. I mean I don't know why it wouldn't be possible.
Thanks,
Matt
It should be possible. I mean I don't know why it wouldn't be possible.
Thanks,
Matt
Re: How hard would this be?
Or a sg05 with the PSU in the case side laying on it's side, case would need to be 2.3 wider.
Re: How hard would this be?
Hello Edward,
Without actually doing the design I do not know how much it will cost. I think the L-Shape template would be a good starting point.
If you need any assistance with designing you can reach out to Protocase customer support. Contact information can be found here https://www.protocase.com/contact/
Best Regards,
Matt
Without actually doing the design I do not know how much it will cost. I think the L-Shape template would be a good starting point.
If you need any assistance with designing you can reach out to Protocase customer support. Contact information can be found here https://www.protocase.com/contact/
Best Regards,
Matt