This is a templated face, and cannot be edited.
Posted: Sun Apr 03, 2022 12:52 pm
Greetings,
I am trying to modify part of an ATX Assembly template but am prompted with the following error: "This is a templated face, and cannot be edited." How can I modify the area above the rear I/O panel of the chassis? It's the part in green in the attached image.
I would like to add some 80mm fan cutouts and or vent cutouts.
TIA,
Zain
I am trying to modify part of an ATX Assembly template but am prompted with the following error: "This is a templated face, and cannot be edited." How can I modify the area above the rear I/O panel of the chassis? It's the part in green in the attached image.
I would like to add some 80mm fan cutouts and or vent cutouts.
TIA,
Zain