ProtocaseDesigner.com

Posted: **Sun Apr 03, 2022 12:52 pm**

Greetings,

I am trying to modify part of an ATX Assembly template but am prompted with the following error: "This is a templated face, and cannot be edited." How can I modify the area above the rear I/O panel of the chassis? It's the part in green in the attached image.

: Rear of Chassis.PNG (24.71 KiB) Viewed 10682 times

I would like to add some 80mm fan cutouts and or vent cutouts.

TIA,
Zain

Posted: **Mon Apr 04, 2022 8:56 am**

Below is the screenshot of the error.

: Error Popup.PNG (36.44 KiB) Viewed 10666 times

The PDA file is located on my GDrive as it is too large to post here.
https://drive.google.com/file/d/1dAQ2jh ... sp=sharing

Posted: **Mon Apr 04, 2022 10:27 am**

Hello Zain,

Some faces are not editable due to manufacturing reasons. However in this case I think it's fine. I have set the particular face you are wanting to edit as editable. Attached is the file.

Matt

24x20x8.75 Case - Black.zip: Updated Computer Enclosure Unlocked Front Flange; (1.45 MiB) Downloaded 742 times

Best Regards,

Posted: **Mon Apr 04, 2022 10:41 am**

Awesome, thanks!

ProtocaseDesigner.com

This is a templated face, and cannot be edited.

This is a templated face, and cannot be edited.

Re: This is a templated face, and cannot be edited.

Re: This is a templated face, and cannot be edited.

Re: This is a templated face, and cannot be edited.