This is a templated face, and cannot be edited.

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
Zain
Posts: 5
Joined: Sun Apr 03, 2022 12:42 pm

This is a templated face, and cannot be edited.

Post by Zain »

Greetings,

I am trying to modify part of an ATX Assembly template but am prompted with the following error: "This is a templated face, and cannot be edited." How can I modify the area above the rear I/O panel of the chassis? It's the part in green in the attached image.

Rear of Chassis.PNG
Rear of Chassis.PNG (24.71 KiB) Viewed 9399 times

I would like to add some 80mm fan cutouts and or vent cutouts.

TIA,
Zain

Zain
Posts: 5
Joined: Sun Apr 03, 2022 12:42 pm

Re: This is a templated face, and cannot be edited.

Post by Zain »

Below is the screenshot of the error.

Error Popup.PNG
Error Popup.PNG (36.44 KiB) Viewed 9383 times

The PDA file is located on my GDrive as it is too large to post here.
https://drive.google.com/file/d/1dAQ2jh ... sp=sharing

mpyne
Site Admin
Posts: 135
Joined: Mon Nov 14, 2016 11:15 am

Re: This is a templated face, and cannot be edited.

Post by mpyne »

Hello Zain,

Some faces are not editable due to manufacturing reasons. However in this case I think it's fine. I have set the particular face you are wanting to edit as editable. Attached is the file.

Matt
24x20x8.75 Case - Black.zip
Updated Computer Enclosure Unlocked Front Flange
(1.45 MiB) Downloaded 538 times
Best Regards,

Zain
Posts: 5
Joined: Sun Apr 03, 2022 12:42 pm

Re: This is a templated face, and cannot be edited.

Post by Zain »

Awesome, thanks!

Post Reply