How hard would this be?

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
edward78
Posts: 38
Joined: Fri Jul 03, 2015 12:37 pm

How hard would this be?

Post by edward78 »

https://www.velkase.com/products/velka-7 oh almost how I want it, accept the GPU is vertical. How easy would it be to have the gpu face the same way as the MB?

mpyne
Site Admin
Posts: 101
Joined: Mon Nov 14, 2016 11:15 am

Re: How hard would this be?

Post by mpyne »

Hello Edward,

It should be possible. I mean I don't know why it wouldn't be possible. :)

Thanks,
Matt

edward78
Posts: 38
Joined: Fri Jul 03, 2015 12:37 pm

Re: How hard would this be?

Post by edward78 »

Or a sg05 with the PSU in the case side laying on it's side, case would need to be 2.3 wider.

edward78
Posts: 38
Joined: Fri Jul 03, 2015 12:37 pm

Re: How hard would this be?

Post by edward78 »

mpyne wrote:
Mon Nov 01, 2021 10:12 am
Hello Edward,

It should be possible. I mean I don't know why it wouldn't be possible. :)

Thanks,
Matt
What would be the $$?

mpyne
Site Admin
Posts: 101
Joined: Mon Nov 14, 2016 11:15 am

Re: How hard would this be?

Post by mpyne »

Hello Edward,

Without actually doing the design I do not know how much it will cost. I think the L-Shape template would be a good starting point.

If you need any assistance with designing you can reach out to Protocase customer support. Contact information can be found here https://www.protocase.com/contact/

Best Regards,
Matt

Post Reply