Guides/rails for shelves
Posted: Sat Oct 02, 2021 5:57 pm
Hi!
I would like to create a set of rails/guides on both sides of a case to insert PCBs or steel shelves against a backplane that would sit on the bottom of the case.
What would be the best way to do this in Designer? I thought about adding two additional panels (one to each side of the case) with bends. Those bends would form the rail/guide on each side.
Pretty much like in the image below.
Is something like this possible at all? It does not have to be exactly like in the picture, but to have the function of a rail/guide.
Thanks in advance!
Xavier.
I would like to create a set of rails/guides on both sides of a case to insert PCBs or steel shelves against a backplane that would sit on the bottom of the case.
What would be the best way to do this in Designer? I thought about adding two additional panels (one to each side of the case) with bends. Those bends would form the rail/guide on each side.
Pretty much like in the image below.
Is something like this possible at all? It does not have to be exactly like in the picture, but to have the function of a rail/guide.
Thanks in advance!
Xavier.