Page 1 of 1
Mac Version 5.6.6 Not Working
Posted: Wed Aug 18, 2021 1:10 pm
by mpyne
Hello guys,
The Mac version was missing several files it needs to run. It appears only fresh installation where effected. If you are unable run Protocase Designer on Mac please try redownloading and installing and you should be good.
Thanks,
Matt
Re: Mac Version 5.6.6 Not Working
Posted: Wed Feb 11, 2026 11:37 pm
by latticedcollar
mpyne wrote: ↑Wed Aug 18, 2021 1:10 pm
Hello guys,
The Mac version was missing several files it needs to run. It appears only fresh installation where effected. If you are unable run Protocase Designer on Mac please try redownloading and installing and you should be good.
Thanks,
Matt
On anodized aluminum panels, studs are typically installed after anodizing, or they’re masked so the anodize doesn’t build up on the contact areas. For rackmount panels, the standard front studs are usually visible hardware and provide sufficient strength when properly specified. If you’re concerned about load-bearing, it’s best to note this in the design notes so the manufacturer can choose the appropriate stud type and installation method.