1U template - Unreachable Front Panel space
Posted: Wed Feb 03, 2021 6:58 pm
Hi folks,
Unless the 1U Rackmount template has changed since I last ordered one of these: The bend flange, bending up from the bottom on the front edge, is not nearly as tall as shown in the cad drawing. In other words, the CAD model does not allow you to use a bit of the front panel (near the lower edge). The delivered enclosure shows a considerable amount of extra panel space that could hold more goodies.
The cad model has the front flange at 0.388" tall from the outside bottom.
My actual delivered box has the flange at 0.268" tall from the outside bottom.
That's an extra 0.1" (all along the bottom), where I could be paying to put more leds!
Regards,
Chris
Rev 5.3.28, Win10
Unless the 1U Rackmount template has changed since I last ordered one of these: The bend flange, bending up from the bottom on the front edge, is not nearly as tall as shown in the cad drawing. In other words, the CAD model does not allow you to use a bit of the front panel (near the lower edge). The delivered enclosure shows a considerable amount of extra panel space that could hold more goodies.
The cad model has the front flange at 0.388" tall from the outside bottom.
My actual delivered box has the flange at 0.268" tall from the outside bottom.
That's an extra 0.1" (all along the bottom), where I could be paying to put more leds!
Regards,
Chris
Rev 5.3.28, Win10