Can't Edit library

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
robert
Posts: 2
Joined: Fri Jul 31, 2020 10:49 pm

Can't Edit library

Post by robert »

Version 5.1.9
No changes I make to a library component (my own) survive changing. IE, I add a fastener then click the green check to accept and close. Upon using or reopening to edit the fastener is not present.

Robert

akirk
Site Admin
Posts: 5
Joined: Tue Jun 17, 2008 8:44 am

Re: Can't Edit library

Post by akirk »

Hi Robert,
From our email conversation yesterday, this is an issue being looked at by our programmers.
In the meantime you are still able to make any changes to a cutout on the face editor and re-save it to the Library.

Cheers,
PhiL

Post Reply