D-Hole Entered Properties
Posted: Thu Jun 25, 2020 2:08 pm
Why are D-hole cutouts specified in the property table as diameter/edge length? I can't say that I've looked at every data sheet specifying a D-hole but every one that I've run across specifies it as diameter/truncated width (ie width of the axis with the flat).
My current workaround (without having to do math) is to model the D-hole in FrontPage Designer, measure the flat, and then enter that dimension in Protocase Designer--which is tedious. Is there a technical reason for the way it is done now?
My current workaround (without having to do math) is to model the D-hole in FrontPage Designer, measure the flat, and then enter that dimension in Protocase Designer--which is tedious. Is there a technical reason for the way it is done now?