Page 1 of 1

Cutout Properties

Posted: Thu Jun 08, 2017 2:40 pm
by trindt
I have some cutouts that I placed for MIL-DTL-38999 series connectors, but the name is too long in the Properties field to verify the size. Is there a way somewhere else in the software where I can see the whole name of the cutout?

Re: Cutout Properties

Posted: Mon Jun 12, 2017 12:58 pm
by Colin
Hello trindt,

you should be able to right click on the cutout in the face editor and select 'properties'.

This properties window should accommodate the lengthy name better.

Colin