Positionning and rotating u shape bracket in 3U enclosure
Posted: Tue Sep 30, 2014 1:45 pm
Hi,
We desperatly try to add a U shape bracket on the base panel of the enclosure, with no success :
- we have built the U shape sub assembly
- we recall it on the case base inside face edit window
- we place it on the right place
- we accept and close
Once back in the case, the U brackett is complitely outside the enclosure.
When we put the brackett on a dummy place to have it correctly placed on the enclosure, we protocase tells us there is some misplacement in the project.
We also have another issue in placing the U shape, we cannot rotate it to place at 90° in the enclosure. The rotate value is not taken into account.
Any idea or advice to manage this bracket placement ?
Many thanks in advance
Philippe
We desperatly try to add a U shape bracket on the base panel of the enclosure, with no success :
- we have built the U shape sub assembly
- we recall it on the case base inside face edit window
- we place it on the right place
- we accept and close
Once back in the case, the U brackett is complitely outside the enclosure.
When we put the brackett on a dummy place to have it correctly placed on the enclosure, we protocase tells us there is some misplacement in the project.
We also have another issue in placing the U shape, we cannot rotate it to place at 90° in the enclosure. The rotate value is not taken into account.
Any idea or advice to manage this bracket placement ?
Many thanks in advance
Philippe