Blind standoffs appear with holes
Posted: Sat Dec 14, 2013 11:26 am
I was working with version 4.3.1 recently, and decided to try out 4.4.0. Going to 4.4, I found that it had trouble opening my 4.3.1 design. I opted to start over, recreating my work so far in a 4.4 project.
My work-in-progress had some blind PEM standoffs, BSO-440-10ZI. I placed the same part number standoffs on the new box. What I currently see are open hole standoffs; looking at the bottom, there are circular holes only, no sign of the PEM's base. Looking back In 4.3.1, I see the hole filled in with an octagonal shape (as expected for this standoff).
If I were to order this box with the 4.4 design, would I get the standoff that the software lists in the text box, rather than what is shown in the main view?
My work-in-progress had some blind PEM standoffs, BSO-440-10ZI. I placed the same part number standoffs on the new box. What I currently see are open hole standoffs; looking at the bottom, there are circular holes only, no sign of the PEM's base. Looking back In 4.3.1, I see the hole filled in with an octagonal shape (as expected for this standoff).
If I were to order this box with the 4.4 design, would I get the standoff that the software lists in the text box, rather than what is shown in the main view?