I was working with version 4.3.1 recently, and decided to try out 4.4.0. Going to 4.4, I found that it had trouble opening my 4.3.1 design. I opted to start over, recreating my work so far in a 4.4 project.
My work-in-progress had some blind PEM standoffs, BSO-440-10ZI. I placed the same part number standoffs on the new box. What I currently see are open hole standoffs; looking at the bottom, there are circular holes only, no sign of the PEM's base. Looking back In 4.3.1, I see the hole filled in with an octagonal shape (as expected for this standoff).
If I were to order this box with the 4.4 design, would I get the standoff that the software lists in the text box, rather than what is shown in the main view?
Blind standoffs appear with holes
Moderators: cduffney, akirk, mpyne, mrodden
-
mpmurphy00
- Posts: 2
- Joined: Sat Dec 14, 2013 10:45 am
Blind standoffs appear with holes
- Attachments
-
- 4.3 box.jpg (19.52 KiB) Viewed 7633 times
-
- 4.4 box.jpg (100.31 KiB) Viewed 7621 times
-
- 4.4 face.jpg (110.4 KiB) Viewed 7624 times
Re: Blind standoffs appear with holes
Hello,
You would get the one listed, we go by part number. I am sorry for the bug in the display, I will look into it!
--Douglas
You would get the one listed, we go by part number. I am sorry for the bug in the display, I will look into it!
--Douglas
--Douglas Ronne
Lead Developer
Lead Developer