Annoying issue with grouping in PC 4 on Linux
Posted: Tue Nov 19, 2013 4:24 pm
I'm trying to place four standoffs at the position of the holes on the circuit board. I place four on the base of the part and then align them to their tops. The really really annoying issue is that if I try and set the distance between them and you try and delete the value in the X-difference column it is very very easy to delete the standoffs. To make the matter even worse undo does not actually bring them back - It makes using the designer almost impossible to use as one small mistake is undoable and forces you to start from scratch on the placement.