Warning saying some cutouts are outside bounds

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
Posts: 353
Joined: Wed Nov 18, 2009 10:54 am

Warning saying some cutouts are outside bounds

Post by dronne »

When you order an enclosure, you may get a warning that some cutouts are outside bounds. You may proceed with the order at this point. There are two possible reasons for the warning:
  1. some enclosures get this error whenever there are PEMs installed. This is a known bug - if the software allowed you to place the PEM it is in a valid location
  2. it is possible to resize enclosures and cause a cutout or PEM to get too close to an edge or actually be off the face. In any case, our tech team will catch this when they review your design and get back to you with options.
--Douglas Ronne
Lead Developer

Post Reply