Cannot place any object on face
Posted: Tue Oct 26, 2010 2:54 pm
Running XP Professional Service Pack 3, fully patched.
Using Protocase Designer v3.12j Build 909.
I watched the cutout placement tutorial.
5ru rackmount case.
Cannot place any cutouts, standoffs, etc on any face. Always says "Invalid Placement Location".
This doesn't look like it should be this difficult.
Thanks,
Stuart
Using Protocase Designer v3.12j Build 909.
I watched the cutout placement tutorial.
5ru rackmount case.
Cannot place any cutouts, standoffs, etc on any face. Always says "Invalid Placement Location".
This doesn't look like it should be this difficult.
Thanks,
Stuart