Page 1 of 1
change stud direction?
Posted: Mon Feb 08, 2010 1:01 am
by chas
if i add a stud to the rear of the enclosure it faces inward. i would like it to face outward. the intended use is as a "chassis ground". i tried editing the inside face of the rear panel, but still the stud faces inward.
Re: change stud direction?
Posted: Mon Feb 08, 2010 9:40 am
by dronne
There are two ways of placing studs facing outwards:
- Place the stud
- right-click on the stud and de-select the "faces inside of case" checkbox
- select the stud to place but don't place it
- press the middle button on your mouse
- place the stud
I hope that helps!
Thank you,
--Douglas Ronne