PEMs Manager in PD Version 3.11

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
CCC
Posts: 1
Joined: Fri Jan 15, 2010 12:26 pm

PEMs Manager in PD Version 3.11

Post by CCC »

In PD Version 3.11 there is a tool called "PEMs Manager". This will be removed in version 3.12 for future down loads (not sure of exact date). This feature is currently for internal (Protocase) use only. It is used to create new fastener sizes that Protocase has available. If you have this tool available in the version you are using you should avoid using it. If you require a fastener that is not available in the stocked list please communicate your custom requirement via email.

Post Reply