Invalid Height or Invalid Width from Cutout Editor

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: cduffney, akirk, mpyne, mrodden

Post Reply
dronne
Posts: 353
Joined: Wed Nov 18, 2009 10:54 am

Invalid Height or Invalid Width from Cutout Editor

Post by dronne »

When making a new cutout you have to enter a height and width. This is an approximate height and width. If you need values less than 1, you must type a leading zero before the decimal. aka 0.5 is good but .5 will not work.
--Douglas Ronne
Lead Developer
Top
Post Reply

Return to “Protocase Designer General Chat / Support”