Mac Version 5.6.6 Not Working

[mpyne]

Hello guys,

The Mac version was missing several files it needs to run. It appears only fresh installation where effected. If you are unable run Protocase Designer on Mac please try redownloading and installing and you should be good.

Thanks,
Matt

[latticedcollar]

Hello guys,

The Mac version was missing several files it needs to run. It appears only fresh installation where effected. If you are unable run Protocase Designer on Mac please try redownloading and installing and you should be good.

Thanks,
Matt

On anodized aluminum panels, studs are typically installed after anodizing, or they’re masked so the anodize doesn’t build up on the contact areas. For rackmount panels, the standard front studs are usually visible hardware and provide sufficient strength when properly specified. If you’re concerned about load-bearing, it’s best to note this in the design notes so the manufacturer can choose the appropriate stud type and installation method.