size for m4 and M3 threaded pocket hole cutout

For general Protocase Designer questions. Anything and everything about Protocase Designer except support questions.

Moderators: Colin, dronne, mpyne, akirk, mrodden

Post Reply
hautcoeur
Posts: 3
Joined: Mon Jan 30, 2023 1:15 pm

size for m4 and M3 threaded pocket hole cutout

Post by hautcoeur »

Hi,

What are the Hole diameter and minimum depth for a M4 Tapped, for Thread M4 X .7 pocket hole, on a 6mm aluminum panel?

What are the Hole diameter and minimum depth for a M3 Tapped, for Thread M3 X .5 pocket hole, on a 6mm aluminum panel?

mpyne
Site Admin
Posts: 137
Joined: Mon Nov 14, 2016 11:15 am

Re: size for m4 and M3 threaded pocket hole cutout

Post by mpyne »

Hello hautcoeur,

m3 = approx 3.11mm
m4= approx 4.15mm

those would be min recommended, but in order to get the min actual you would need to pitch to get 2 threads, which is what I would say would be the overall min so say 2mm for the m3, and 3mm for the 4mm approx in order to allow for 2 turns plus some screw clearance.

Thanks, Matt

hautcoeur
Posts: 3
Joined: Mon Jan 30, 2023 1:15 pm

Re: size for m4 and M3 threaded pocket hole cutout

Post by hautcoeur »

Hi, thanks for that first reply.

So these are the minimum depth.
But what are the holes diameter?

Thank you

mpyne
Site Admin
Posts: 137
Joined: Mon Nov 14, 2016 11:15 am

Re: size for m4 and M3 threaded pocket hole cutout

Post by mpyne »

Ops, was focused on the depth. Here you go.

M4 X .7
Diameter = 4mm
Tap drill size = 3.3mm

M3 X .5
Diameter = 3mm
Tap drill size = 2.5mm

hautcoeur
Posts: 3
Joined: Mon Jan 30, 2023 1:15 pm

Re: size for m4 and M3 threaded pocket hole cutout

Post by hautcoeur »

Thank you

Post Reply