ProtocaseDesigner.com

Hi if snap to grid is on and we select and object. The object automatically snaps to the grid even if it's marked as locked. I think the snap should only happen if we attempt to move the object by mouse.

It is particularly annoying when a cutout that is not aligned to grid and you have snap on and you click to check that item and it gets moved.

I just ran into this.

This is really bad behavior. It took me a while to figure out why PD was moving stuff around without me asking it to.

I have a video of the offending behavior if needed.

Please fix this asap.

Hello Chris,

I agree this behavior is not good. We have been planing to update it for while but just didn't have the resources. It should only take me a little bit of time so I'll look at this week.

Thanks
Matt

Fixed should be going out in version 5.5

Matt