Origin of top and bottom panels
Moderators: cduffney, akirk, mpyne, mrodden
Origin of top and bottom panels
I could use some help, while editing a bottom panel for a 1U the origin for the panel became offset from the main display origin. How do I get it back?
- Attachments
-
- Capture.PNG (3.06 KiB) Viewed 18930 times
Re: Origin of top and bottom panels
Hello vak6819,
The red origin should match the position the of the red origin you see in the 3D but shown in 2D. We call this origin the assembly view origin. Unfortunately I can't think of any way to adjust that origin sorry.
Some times we update the origin locations to make more sense with your production workflow, maybe this is the case. Have you updated Protocase Designer recently? In the updated version we may have updated our templates.
Let me know if there is any other questions.
Thanks,
Matt
The red origin should match the position the of the red origin you see in the 3D but shown in 2D. We call this origin the assembly view origin. Unfortunately I can't think of any way to adjust that origin sorry.
Some times we update the origin locations to make more sense with your production workflow, maybe this is the case. Have you updated Protocase Designer recently? In the updated version we may have updated our templates.
Let me know if there is any other questions.
Thanks,
Matt