ProtocaseDesigner.com

Hey Colin - thanks for the fast response. I'll email the file in tonight.

-David

Hello - Still making progress on my enclosure and getting ready to order. I have two questions though... First, am I correct that, with the sloped top enclosure, the measurements are viewed from directly above, parallel to the base (ground), not parallel to the sloped top? In other words, If I want ...

Thank you, that’s super helpful. Making progress now.

Alternatively, is there a way to just enter the coordinates for cutouts on that face in reference to the green arrow (the origin point for that face)? I just really need to be able to enter the cutout locations on that face, but I want to get them right. I don’t want to just eye it or guess how much...

Thanks for the response. Sure, a picture is attached (hopefully). You can see the red arrow is down below (off of) the face. I'm not sure why the enclosure's origin would not be within this face.

When I create a Sloped Top Consolet enclosure, then open the face editor for the top face, the red origin arrow is located about 0.34" below the bottom edge of that face. The green arrow is located where I think the origin point should be. I must not be understanding this correctly. When I create ot...