ProtocaseDesigner.com

u-shape and i need some holes close to the front on the top and bottom panels. i needed a hole to free-fit a #6 thread, something like .150, about .200 from the edge.

when you are saving in gimp you can de-select the 'save transparency' -- i ran into this problem myself.

can you countersink small holes (.125") or is that something i will do on my end? there should be sufficient material to countersink for an M3 in the .080" (12 guage) aluminum sheet metal (assuming i can get my enclosure in that material).

the mounts for my board are close to the edge of the enclosure. so close that it would be in the red no-go regions. i need to place 4 0.125" holes at 0.280" offset toward the inside. however, the min distance appears to be 0.400".

if i add a stud to the rear of the enclosure it faces inward. i would like it to face outward. the intended use is as a "chassis ground". i tried editing the inside face of the rear panel, but still the stud faces inward.